Product Description|PRODUCT DESCRIPTION

This product is a single-component waterproof coating made by polymerizing advanced technology and raw materials, and when using itAdding an appropriate amount of cement to this product and mixing it evenly is equivalent to a cement-based polymer.(K11)Use.The quality and effect are the same as cement-based polymer waterproof coatings, with high film strength and large elongation, and canDirectly apply tiles or latex paint on the coating. Since this product is a concentrated type,It saved a large amount of packaging and transportation costs for a wide range of users.

Product Features|PRODUCT FEATURES

◆It has good bonding performance with the concrete substrate, effectively preventing tiles from falling off.

◆Water-based and environmentally friendly, does not contain harmful substances such as toluene or formaldehyde, and can be used for waterproofing drinking water pools;

◆The colors are bright, which can effectively prevent missed spots during brushing and also have a certain decorative effect;

◆Aging-resistant, resistant to high and low temperature changes, with a long service life.

Scope of Application|SCOPE OF APPLICATION

①Especially suitable for waterproofing and moisture-proof engineering of porous new masonry materials such as aerated concrete and hollow bricks;

②Waterproofing and moisture-proofing works for roofs, basements, toilets and bathrooms, kitchens, and walls of industrial and civil buildings;

③Suitable for waterproofing projects of reservoirs, swimming pools, and tanks that have health and environmental protection requirements.

Construction Guide|CONSTRUCTION GUIDE

Construction method

1.The base surface should be flat, solid, clean, and free of visible water.;

2.Slowly add the cement to the masterbatch, stir thoroughly until uniform and free of granules, then let it stand.FiveCan be applied in minutes(The base surface should be fully prepared before paintingmoist);

3.Coating Essentials:

①Apply with a roller or brush, completing layer by layer according to the specified process sequence;

②If the paint has sediment, it should be stirred evenly immediately;

③Apply the coating as evenly as possible, avoiding local accumulation; it is preferable to apply thin layers multiple times.

④The interval between the application of each coating should be based on the previous layer being dry to the touch and not sticky.

Storage, Transportation, and Packaging

Saved in5℃The above-mentioned shaded areas and powder materials should be stored in a dry place, with attention to moisture and sun protection, and shelf life.Twelvemonths (stored at room temperature).

Precautions

Please do not enter5℃Construction may proceed in the following or in the rain, but it is not recommended if the humidity is too high; not suitable for areas with large deformations.