Product Description|PRODUCT DESCRIPTION

This product is made of high-tech new polymers and high-grade pigments. It is different from the commonly used epoxy resins on the market.Zhi Mei seam filler, it has extremely strong UV resistance. It is especially suitable for tiles exposed to sunlight for long periods.Filling and decorating the joints of substrates such as marble and stone, and at the same time, it is also very suitable for highly corrosive environments.The filling of the gaps at the edges and the joints.

Product Features|PRODUCT FEATURES

◆Does not yellow outdoors,Resistant to ultraviolet aging;

◆Low-temperature rapid drying,below zeroTen℃ can be used normally;

◆High hardness,Scratch-resistant,Abrasion-resistant,Prevent darkening,Acid and alkali resistant;

◆Fill completely during construction,One-time forming,The wall surface construction does not sag.

Scope of Application|SCOPE OF APPLICATION

Suitable for all kinds of tiles, Grouting of stone and other materials, Waterproof, Mold-resistant and other seam decoration.

Construction Guide|CONSTRUCTION GUIDE

Construction Process

First, attach the special glue nozzle. Then put on the dedicated high-quality labor-saving glue gun, Before the nozzle dispenses glue, point the nozzle upwards to apply glue, Make the glue stay in the middle part of the nozzle

thoroughly mixed Glue can only be applied after the nozzle starts dispensing.

Construction Key Points

①Clean the grooves and ensure that there is no water or powder in the gaps to prevent the surface from peeling easily after construction.

②Stick masking tape or adhesive tape along the edges of the groove, then apply glue;

③Use a labor-saving glue gun for construction, first apply about40CMDiscard unused rubber material and ensure the rubber material is mixed evenly;

④Apply sealant along the gap, and the diameter of the nozzle should be smaller than the width of the gap, preferably less rather than more, to avoid overflow of the sealant;

⑤After applying the glue, use a round stick to smooth and straighten the glue strip. Before the adhesive dries, you can peel off the masking tape or adhesive tape if there is any overflow of glue.Wipe with alcohol or use a spatula to scrape off after the adhesive has cured.

⑥Let stand3~5It reaches initial curing after a few hours and completely cures the next day, bright and glossy like porcelain.

Storage, Transportation, and Packaging

①stored in5-30℃Keep within temperature limits, strictly avoid exposure to sunlight and freezing, shelf lifeTwelvemonth;

②Packaging specifications:400ml/Group.

Precautions

①During the construction process, if the interruption exceeds approximatelyTwentyWhen the adhesive is not applied continuously for minutes, the colloid in the mixing tube has already begun to solidify, making it difficult to apply the adhesive.Or when it cannot be hit,Then a new mixing tube needs to be replaced.

②For the adhesive remaining in the hose, first unscrew the mixing nozzle, wipe off the adhesive overflow at the hose tip, then screw on the adhesive cap tightly for storage, to be used next time.When needed,You can continue to use it by replacing it with a new hybrid tube.